Curtis IP320UKT Bedienungsanleitung PDF herunterladen (Seite 10)

MODEL : 48652

• User guide

• Remote control

www.curtisint.com

Setting the Alarm

a. Press the ALARM SET 1 button and the alarm icon show on display. Setting the

Alarm

b. Press and hold the ALARM SET 1 button.

c. Press the FWD/TUNE button to cycle up through the hours, or press the REV/TUNE

button to cycle down through the hours. Press the ALARM SET 1 button to select

the hour.

d. Press the FWD/TUNE button to cycle up through the minutes, or press the REV/

TUNE button to cycle down through the minutes. Press the ALARM SET 1 button to

select the minute.

e. Press the FWD/TUNE or REV/TUNE buttons to cycle through the dierent alarm

source (Radio, Buzzer, or iPod). After a mode is selected press the ALARM SET 1

button to nish setting the alarm.

Active or Deactivate the Alarm Function

a. To turn o the alarm completely(not reset for next day). Press and hold the AL 1

(AL 2) Button approx. 1 second then release. The AL 1 (AL 2) Indicator will disappear

on the display.

b. To active the alarm again at the same time . Press and hold the AL 1 (AL 2) Button

approx. 1 second then release. The AL 1 (AL 2) Indicator will appear on the display.

The alarm will goes o as the previously set time.

Warning:

This operation also applies to setting alarm two.

Alarm will not operation when the unit in power on mode.

If wake up mode was set to iPod (iPod/iPhone), make sure the iPod/ iPhone was inserted

in the docking properly and the volume was set to suitable level. Otherwise, when Alarm

goes o, no sound output from the speaker or sound weak.

When alarm sounding, press the POWER button to stop the alarm sound and the alarm

will automatic repeat next day.

•

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Curtis IP320UKT Bedienungsanleitung Seite 10