Curtis LCD2277 Bedienungsanleitung Seite 18
- Seite / 40
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
33
32
APPENDIXAPPENDIX
According to the device species, it is possible to display image normally.
In this condition, please adjust as following steps.
DEFECT JUDGEMENT
TROUBLESHOOTING
Phenomena
No picture, Indicator
light if off.
Display “NO SYNC
SIGNAL”, no picture,
Indicator light is green.
Display “Invalid Scan
Fred” on the screen
when you connect
to a computer.
1. Check the signal cable is properly connected.
2. Make sure the power switch of computer and video
Device is on.
3.Make sure
the computer is not under electricity-saving
Mode.
4. Check input whether match the interface.
Check Parts
Could not receive the input signal normally.
1. Check whether the computer resolution has been out of
Television resolution range.
2. Check the signal cable is properly connected.
1.Check the connection of Power cord.
2. Connect to the power switch.
Power indicator light is
normal, but no picture.
The image appears distorted.
The text on the screen appears
vertical streaks, and character
is not clear.
The text on the screen is not
clear. The picture appears
shaking when display.
The remote control
doesn't work.
1.Check the contrast ratio and brightness setting
(increase
the contrast ratio and brightness setting)
Adjust point pulse rate and phase position.
(First to adjust Point pulse rate, then adjust
the phase position.) (RGB input)
Adjust the point impulse phase position to
get optimization effect. (RGB)
1. Check whether the remote control has installed
with the batteries and polarity.
2. Check
whether the batteries are good.
3. Check whether the batteries have been dead.
TROUBLESHOOTING
Attempt the following steps to diagnose the symptom you have seen. If the
symptom couldn’t be corrected, please contact the dealer.
The Symptom of Trouble
Possible causes
Correct measures
Symptom
There are spots on the
screen, and the sound
is not clear when you
watch TV.
The picture is doubled
or tripled,
but sound is good.
Disturb Intermittent
No picture & No sound
1. The antenna cables may be
disconnected.
2. The antenna cables may be
disconnected or cankered.
3. The
antenna cables may be
weak.
4. The weather is bad.
5. The transmitter is wrong.
1. The antenna cables may be
weak.
2. The television could not
tune correctly.
3. The weather is bad
4. The transmitter is wrong.
5. Television input incorrectly.
Your unit is being affected by
other television, automobiles,
fluorescent lamps,
portable radio.
1. Television is under AV mode.
2. The picture and volume are
set to minimum.
3. The television is under sleep
mode or electricity-saving mode.
1. Connect antenna cables
again or change the plug.
2. Connect antenna cables
again or change new cables.
3. Adjust antenna again.
4. There is no need to correct.
5. Check with local operator.
1. Adjust antenna again.
2. Search channels again or
adjust television.
3. There is no need to correct.
4. Check with local operator.
5. Check the outside devices.
Check the shield contains of
television and put the
television as far away
as
possible through cables.
1. Check the picture/sound
control (enter main menu).
2. Make sure power in on.
NOTE : Consumer should not repair by yourself, high-voltage is in unit, please
request professional worker to repair if meet trouble.
- CONTENTS 2
- SAFTEY INTRODUCTIONS 3
- SAFETY INTRODUCTIONS 4
- ANTENNA CONNECTION 10
- YPbPr CONNECTION 11
- PC CONNECTION 12
- S-VIDEO CONNECTION 12
- HDMI CONNECTION 12
- EARPHONE CONNECTION 12
- S-Video YPbPr VGA HDMI 13
- OSD OPERATION OSD OPERATION 14
- OSD OPERATION 17
- APPENDIXAPPENDIX 18
- APPENDIX 20
- MANUEL DE 21
- L'UTILISATEUR TV LCD 21
- SOMMAIRE 22
- CONSIGNE DE SÉCURITÉ 23
- ACCESSORIES 23
- INTRODUCTION 26
- INSTALLATION 28
- ANTENNE CONNEXION 30
- ANTENNE DE CONNEXION 30
- Caméscope 31
- Jeu vidéo 31
- CONNEXION PC 32
- CONNEXION S-VIDEO 32
- CONNEXION HDMI 32
- CONNECTION ÉCOUTEUR 32
- FONCTIONNEMENT OSD 34
- DÉPANNAGE 38
- ANNEXEANNEXE 39
- SPECIFICATION DE PRODUCT 40
Verwandte Produkte und Handbücher für LCD-Fernseher Curtis LCD2277
LCD-Fernseher Curtis LCD3718A Datenblatt
(1 Seiten)
(1 Seiten)
LCD-Fernseher Curtis LCDVD152AC Datenblatt
(1 Seiten)
(1 Seiten)
LCD-Fernseher Curtis LCD1105A Bedienerhandbuch
(21 Seiten)
(21 Seiten)
LCD-Fernseher Curtis LCD2277 Bedienungsanleitung
(32 Seiten)
(32 Seiten)
LCD-Fernseher Curtis LCD 1922A Betriebsanleitung
(23 Seiten)
(23 Seiten)
LCD-Fernseher Curtis LCDVD152 Betriebsanleitung
(38 Seiten)
(38 Seiten)
LCD-Fernseher Curtis LCD2622 Bedienungsanleitung
(19 Seiten)
(19 Seiten)
LCD-Fernseher Curtis LCD4065A Bedienerhandbuch
(35 Seiten)
(35 Seiten)
LCD-Fernseher Curtis LCD1922 Betriebsanleitung
(33 Seiten)
(33 Seiten)
LCD-Fernseher Curtis LCD2603A Betriebsanleitung
(38 Seiten)
(38 Seiten)
LCD-Fernseher Curtis LCD1933 Spezifikationen
(39 Seiten)
(39 Seiten)
LCD-Fernseher Curtis LCD1924 Spezifikationen
(57 Seiten)
(57 Seiten)
LCD-Fernseher Curtis LCD3798 Spezifikationen
(66 Seiten)
(66 Seiten)
LCD-Fernseher Curtis LCD3798 Spezifikationen
(46 Seiten)
(46 Seiten)
LCD-Fernseher Curtis LCD1911 Bedienungsanleitung
(81 Seiten)
(81 Seiten)
Pioneer MVH-P8200BT manuels
Manuels d'utilisation et guides de l'utilisateur pour Vidéo de voiture Pioneer MVH-P8200BT.
Nous fournissons des manuels en pdf 1 Pioneer MVH-P8200BT à télécharger gratuitement par type de document : Manuel de l'utilisateur
Kommentare zu diesen Handbüchern